Product Description:
JK2515B-16S multiplex resistance scanning tester (16) using 240*128 lattice LCD disy, can be used for transformer, motor, switch, relay and other types of multiplex resistance synchronous test, instrument
Measuring range 0.0001Ω~19.999kΩ, the instrument produces high precision constant flow through the measured parts for four end measurement, effectively deducting lead error, suitable for users to make high precision measurement; Due to the use of DC testing and
Up to ten groups of fast scanning test, especially suitable for copper resistance measurement of various transformers and inductors; The user can perform two kinds of sorting, namely the upper/lower limit sorting of the resistance directly disyed value and the Δ% sorting. In addition,
Single point or scan two zero clearing calibration modes; Test changes in speed (fast, slow); Full state, full set value of power protection and other functions are also greatly convenient for users to test the product
Product application:
Measurement of various high, medium and low value resistors
Contact resistance of various switches
Enamelled wire resistance
Connector contact resistance
Relay wire package and contact resistance
Transformer, inductor, motor, deflection coil winding resistance
Solder joint contact resistance
Conductor resistance
Metal riveting resistors for cars, ships, and aircraft
Printed te lines and perforated resistors
Characterizing the low resistance characteristics of electromechanical components
Metal inspection, etc.
Performance Characteristics :
User-friendly operation interface, easy operation and maintenance
A single machine can scan up to 24 channels
Each way has a sorting setting
Standard RS-232C interface
Technical parameters:
| Product model | JK2515B-16S
|
Basic accuracy |
0.05percent read 1 word |
Measuring range : |
0.1 mΩ -- 2 MΩ(custom) 0.01 mΩ -- 200 kΩ (standard) |
Highest resolution : |
10uΩ |
Single channel speed: |
6 times per second,12 times per second |
Range mode: |
Manual, automatic, range hold |
Zero clearing function: |
Short circuit |
Test end: |
5 terminal |
Disy mode |
直读、Δ% |
Sorting function |
Top pass, bottom pass, pass |
With RS232 interface |
|
Sort: |
Direct reading (Dire) |
Alarm mode (--) |
1:. Turn off the alarm (Clo)
|
Note: Above or below is unqualified |
|
Clear mode selection:
1> . Single load zero clearing (Point)
- Note: Only works in scan tests
Range: 1> . Auto 2> . Hold (Hold)
Multichannel scanning sub-signal selection mode:
A: All sweep results, take 16 channels as an example: all 16 channels can only be in the same upper limit and the same lower limit, set the upper and lower limit value range (only in the same range) beyond the range to determine whether qualified or unqualified output signal (high level, low level)
B: Scan the results successively. Take the 16-channel as an example: set the upper and lower limit value range for each channel (only in the same range), and can classify the output signal (high level, low level) qualified or unqualified, and then enter the next channel to test the results.
C: The results are obtained after all scanning. Take 16 channels as an example: set different upper and lower limit value ranges for each channel (only in the same range). The results are obtained after all 16 channels are scanned to determine whether the signal is qualified or unqualified (high level, low level)
